NUCLEO-H723ZG at 520 MHz: die temperature under full load (2026-11-16/17)

The owner asked how warm the board gets in its closed cabinet at 520 MHz (the fast-clock option, common/stm32h723/board.h, BOARD_CLOCK_FAST). firmware/h7-thermal logs the die temperature from the chip's digital temperature sensor (factory calibration T0 30 C, FMT0 711.0 kHz, ramp 2035 Hz/C) while the core runs FPU and integer work on DTCM data at 520 MHz, then cools at 64 MHz. Stop at 85 C (never reached); VOS0 allows a junction temperature of 105 C (DS13313 Rev 5).

Run Idle 64 MHz Load 520 MHz Peak End of load Cooled to
short (1/10/5 min, 1 s samples) 31 C 10 min 50.0 C 49.7 C 34.2 C after 5 min
long (5/60/45 min, 2 s samples) 32.2 C 60 min 52.3 C 51.5 C 31.1 C after 45 min

Long run during the load: +1 min 44.1 C, +5 min 48.0, +10 min 49.7, +20 min 51.2, +30 min 51.2, +40 min 51.5, +60 min 51.7.

Time constants (sum of three exponentials fitted to the long run, rms 0.18-0.19 C, about the sensor's step; grid fit, so the values are rough):

Load Cooling What it is
step at the switch < 2 s < 2 s the die (faster than the samples)
fast 6 s, +5.4 C 8 s, -4.9 C die and package
middle 300 s, +6.9 C 300 s, -6.2 C the board's copper
slow ~900 s, +1.5 C ~900 s, -2.3 C board as a whole, cabinet air

Records: ~/lab-runs/stm32h723-thermal-20261116T210635Z.json (short), ~/lab-runs/stm32h723-thermal-20261116T213319Z.json (long).